3d_print_submittal
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
3d_print_submittal [2020/02/15 17:14] zwmm |
3d_print_submittal [2020/02/15 17:23] zwmm |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| Discuss improvements here: | Discuss improvements here: | ||
| - Add a column to the form guaranteeing that your submission is safe for overnight printing. | - Add a column to the form guaranteeing that your submission is safe for overnight printing. | ||
| + | - Add buttons to the sheet to set start time and finish time | ||
| + | - Typical spreadsheet scenario. | ||
| + | - The current design is low maintenance, except for the gory details of the QueueSubmission macro. We need to resist adding to that macro until it is unusable | ||
| + | - does not require our own server | ||
| + | - can be maintained and improved by any number of collaborative developers | ||
| + | - Any security risk? | ||
| + | - should be able to keep your identity out of the form. For example, have a contact list only local in the Smelly Room, and use an alias listed there in the Google Form. | ||
3d_print_submittal.txt · Last modified: 2020/02/15 17:23 by zwmm
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
