This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
3d_printer [2019/01/29 15:28] zwmm |
3d_printer [2019/07/26 15:53] glassgiant |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | **There is a short checkout procedure all members must undergo before starting to use the 3D printers. | + | {{ : |
- | Our main 3D printer is a [[https:// | + | Our main 3D printer is a [[https:// |
- | Our new printer is a Prusa MK3. | + | [[Prusa MK3 Usage Instructions]] |
The user manual is in the Documents\3dprints folder on the laptop next to the laser cutter and this printer. | The user manual is in the Documents\3dprints folder on the laptop next to the laser cutter and this printer. | ||
A Raspberry Pi 3 has been added to run Octoprint, so you can monitor and control your job remotely. Instructions here: [[prusa_octoprint_instructions|Prusa Octoprint Instructions]]. | A Raspberry Pi 3 has been added to run Octoprint, so you can monitor and control your job remotely. Instructions here: [[prusa_octoprint_instructions|Prusa Octoprint Instructions]]. | ||
+ | |||
+ | {{: | ||
+ | Eurekatec is a friendly local supplier (5 minutes drive from the Space in Lr. Sackville) who stock filament. Mohammed is now making his own filament from high quality raw material specifically engineered for 2d printing. | ||
+ | |||
+ | If you have done a substantial amount of printing, you should contribute to our inventory of filament. Ask in the [[https:// | ||