User Tools

Site Tools


cnc_mill

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
cnc_mill [2019/07/26 15:39]
glassgiant
cnc_mill [2020/12/01 13:22] (current)
glassgiant
Line 4: Line 4:
 {{ :​tools:​cnc:​2019-07-06_12.59.24.jpg?​400|}}Will do approximately 11x15 inches.  ​ {{ :​tools:​cnc:​2019-07-06_12.59.24.jpg?​400|}}Will do approximately 11x15 inches.  ​
  
-The file types can be most anything, but typically we use an SVG file in Inkscape, preparing it for the CNC using PartKam.com,​ and milling with Mach 3.  ​+The file types can be most anything, but typically we use an SVG file in Inkscape, preparing it for the CNC using PartKam.com, ​testing the GCode with NCViewer.com ​and milling with Mach 3.  ​
  
-The CNC is open to all Halifax Makerspace members to use once training has been completed. To arrange for training, please ​talk to a director.+The CNC is open to all Halifax Makerspace members to use once training has been completed. To arrange for training, please ​email us.
  
 Recommended settings: Recommended settings:
-For hardwood with 1/8" single flute end mill bit: spindle speed of 400, feed rate of 60 in/​min, ​plung of 30 in/min.+For hardwood with 1/8" single flute end mill bit: spindle speed of 400, feed rate of 60 in/​min, ​plunge ​of 30 in/min.
  
cnc_mill.txt · Last modified: 2020/12/01 13:22 by glassgiant