User Tools

Site Tools


hal-con_2015_pinball_project

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
hal-con_2015_pinball_project [2015/05/08 11:29]
spierepf
hal-con_2015_pinball_project [2015/05/08 11:32]
spierepf [State of the Project]
Line 186: Line 186:
   * tidy up the wiring   * tidy up the wiring
   * heavier ground wire   * heavier ground wire
 +  * Choke/toroid on flipper wires
  
 ====== State of the Project ====== ====== State of the Project ======
  
- Cabinet+=== Cabinet ===
    * Finish sanding and priming (There are a few places where the grain is showing through the primer, we would like to clean those up)    * Finish sanding and priming (There are a few places where the grain is showing through the primer, we would like to clean those up)
    * Legs (We have the old set that came with our donor machine that need to be:)    * Legs (We have the old set that came with our donor machine that need to be:)
Line 208: Line 209:
      * Legs      * Legs
  
- Software+=== Software ===
    * Raspberry Pi (mainboard)    * Raspberry Pi (mainboard)
      * Raspbian OS      * Raspbian OS
Line 220: Line 221:
        * We are planning to go with the Fade Candy board (http://www.adafruit.com/product/1689) since it is directly supported by Mission Pinball (see above)        * We are planning to go with the Fade Candy board (http://www.adafruit.com/product/1689) since it is directly supported by Mission Pinball (see above)
  
- Playfield (This is by far the critical path)+=== Playfield === 
 +(This is by far the critical path)
    * Layout (There will be a forthcoming document for consideration and approval by Hal-Con)    * Layout (There will be a forthcoming document for consideration and approval by Hal-Con)
    * Artwork    * Artwork
hal-con_2015_pinball_project.txt · Last modified: 2015/08/02 10:59 by spierepf