This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
laser_cutter [2018/02/14 02:44] zwmm [Monitoring] |
laser_cutter [2018/11/29 19:02] zwmm |
||
---|---|---|---|
Line 21: | Line 21: | ||
- Ensure the vent blast gate is open. | - Ensure the vent blast gate is open. | ||
- Ensure the vent fan is running. With the lid closed, you should be able to feel air being drawn into the front vents of the laser cutter. | - Ensure the vent fan is running. With the lid closed, you should be able to feel air being drawn into the front vents of the laser cutter. | ||
+ | - Ensure the compressor has been recently drained. [[How to drain the compressor]] | ||
- Ensure the compressor is on and air is coming out near the lens by feeling it with your hand. | - Ensure the compressor is on and air is coming out near the lens by feeling it with your hand. | ||
- | - If there are any problems, stuff doesn' | + | - If there are any problems, stuff doesn' |
===== Post-Cutting Checklist ===== | ===== Post-Cutting Checklist ===== | ||
Line 45: | Line 46: | ||
===== Monitoring ===== | ===== Monitoring ===== | ||
- | We've installed a nodeMCU on the wall which is monitoring | + | We've installed a nodeMCU on the wall which is monitoring the temperature in the vent tube and the position of the blast gate. The recent temperature |
- | You can also subscribe to hmslasermonitor on [[https:// | + | You can also subscribe to hmslasermonitor on [[https:// |
There are various commands you can send to the bot, including one to get an update of the current vent conditions. | There are various commands you can send to the bot, including one to get an update of the current vent conditions. |