laser_tripwire_rubber_band_shooter
This is an old revision of the document!
Table of Contents
How it works
A laser constantly shines on a photoresistor. The Arduino constantly reads the voltage from a voltage divider made from a photoresistor and a 20k resistor. When a person interrupts the laser beam, the resistance of the photoresistor drops. The Arduino detects this as a change in voltage and sends a signal to the servo to change positions, releasing a rubber band.
Wiring Diagram
Voltage Divider Equation
laser_tripwire_rubber_band_shooter.1533747716.txt.gz · Last modified: 2018/08/08 17:01 by glassgiant
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
