User Tools

Site Tools


maslow_cnc_mill

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

maslow_cnc_mill [2018/09/17 14:19]
glassgiant created
maslow_cnc_mill [2019/07/26 15:43] (current)
glassgiant
Line 1: Line 1:
-The Maslow CNC will take a full 8x4' sheet. ** It requires a special training session before members can use it.**  At the time of this writing, it's been used only a handful of times.  ​Peter would be the best person to contact to learn to use it.+The Maslow CNC will take a full 8x4' sheet at up to 3/4" thick. ** It requires a special training session before members can use it.**   ​Peter would be the best person to contact to learn to use it. 
 + 
 +You can start with almost any file type, but typically we use an Inkscape SVG, run it through PartKam.com to produce the GCode. ​ The mill itself uses Ground Control to run the GCode. 
 + 
 +Recommended settings: feed rate 20 inches per minute
  
 {{:​tools:​maslow.jpg?​400|}} {{:​tools:​maslow.jpg?​400|}}
maslow_cnc_mill.1537193954.txt.gz · Last modified: 2018/09/17 14:19 by glassgiant