User Tools

Site Tools


scroll_saw

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
scroll_saw [2017/08/22 17:35]
glassgiant created
scroll_saw [2017/10/03 18:56]
glassgiant
Line 1: Line 1:
-====== ​Jigsaw ​======+====== ​Craftsman 16" Direct Drive Scrollsaw ​====== 
 +{{ :​2017-08-18_10.43.49.jpg?​500|}} 
 +===== Consumables ===== 
 +5" pin-end scroll saw blades 
 + 
 +===== About ===== 
 + 
 +Scrollsaws are typically used in one or more of the following circumstances:​ 
 +  * Cuts are in the interior of a workpiece (holes). ​ In this case, you would typically drill a hole big enough to feed the scrollsaw blade through, then reconnect the blade, make your cut, disconnect the blade and pull it back out of the piece. 
 +  * A very clean cut is needed. ​ The scroll saw tends not to produce a lot of blowout (splintery cuts). ​ By contrast, the jig saw, which would be a comparable saw in many regards, tends to produce very rough cuts. 
 +  * Very tight curves are needed. ​ Scroll work is a science/art in and of itself. ​ A whole field of woodworking exists around scroll saws and their handtool cousins, the fret saw.  These are usually intricate, ornamental pieces. ​ A scrollsaw will cut a tigher curve than either a bandsaw or jigsaw. 
 + 
 +The manual for this tool, including directions on changing blades, is {{:​tools:​craftsman_16inch_scrollsaw.pdf|here}}. 
 + 
 +{{:​2017-08-18_10.43.53.jpg?​500|}}
  
  
scroll_saw.txt · Last modified: 2017/10/03 18:56 by glassgiant